Manual for FD

Radio codes:

10-1 - responding
10-2 - Arriving at the scene
10-3 - Negative
10-4 - Affirmative / roger that
10-5 - Repeat
10-10 - Status report (Your status, location and such)
10-12 - Backup
10-20 - Location
10-22 - Disegard last message
10-30 - Patroling
10-31 - Returning to the station
10-32 - Returning to the station with patient
10-50 - Accident
10-90 - Roll call
10-98 - Assignment failed
10-99 - Assignment succesfull

Status 1 - Going on duty
Status 2 - Going off duty
Status 3 - Stand by (Filling fuel to your car, getting something to eat and such)

Fire classes

Most common fire class is A - ordinary combustible. These occur when a solid, organic material such as wood, cloth, rubber, or some plastics[1] become heated to their ignition point. At this point the material undergoes combustion and will continue burning as long as the four components of the fire tetrahedron (heat, fuel, oxygen, and the sustaining chemical reaction) are available. when a class-A fire burns in a less-restricted environment the fire can quickly grow out of control and become a wildfire. This is the case when firefighting and fire control techniques are required. This class of fire is fairly simple to fight and contain—by simply removing the heat, oxygen, or fuel, or by suppressing the underlying chemical reaction, the fire tetrahedron collapses and the fire dies out. The most common way to do this is by removing heat by spraying the burning material with water; oxygen can be removed by smothering the fire with foam from a fire extinguisher.

Class B - Flammable liquid and gas - The most effective way to extinguish a liquid or gas fueled fire is by inhibiting the chemical chain reaction of the fire, which is done by dry chemical and Halon extinguishing agents, although smothering with CO2 or, for liquids, foam is also effective.


Class C - Electrical Fires - When electrical equipment gets on fire. These should not be sprayed with normal fire estinguishers or any other equipment that uses fire! It can be fought with any extinguishing agent rated for electrical fire.

Other

A fire extinguisher, flame extinguisher, or simply an extinguisher, is an active fire protection device used to extinguish or control small fires, often in emergency situations. It is not intended for use on an out-of-control fire, such as one which has reached the ceiling, endangers the user (i.e., no escape route, smoke, explosion hazard, etc.).

MEDICAL

When you arrive on scene where the victim is, first you need to do is check their pulse. To check the victim's pulse you need to put your fingers on his neck or you could use EKG Heart rate monitor.

If the pulse is low, use a syringle with special liquid and gently stab it in the vein.
If the pulse is high, stab it in the neck.

Defibrillation is a common treatment for life-threatening cardiac arrhythmias, ventricular fibrillation, and pulseless ventricular tachycardia. Defibrillation consists of delivering a therapeutic dose of electrical energy to the affected heart with a device called a defibrillator. This depolarizes a critical mass of the heart muscle, terminates the arrhythmia, and allows normal sinus rhythm to be reestablished by the body's natural pacemaker, in the sinoatrial node of the heart.

An automated external defibrillator or AED is a portable electronic device that automatically diagnoses the potentially life threatening cardiac arrhythmias of ventricular fibrillation and ventricular tachycardia in a patient,[1] and is able to treat them through defibrillation, the application of electrical therapy which stops the arrhythmia, allowing the heart to reestablish an effective rhythm.


You could always call an medical unit if you don't know what to do.


FD Vehicles and their equipment


Engine 1 also known as E1 is used for fires it can be used by Fire Engineer and higher or any lower rank that has premission from High Command. E1 Equipment: Fire hoses, Gas Mask, Gas tank, Fire estinguisher, JoL equipment (Chainsaw etc.), First Aid Kid and AED.

Engine 2 E2 has same usage as E2 and same equipment.
Same goes with other Engines.

Basic Life Support vehicle ((Ambulance)) is used for medical support. It contains: AED, First Aid Kit, Fire Estinguisher, Stretcher to transport patients and other important medical stuff.

FIRE

When there is a call about fire, all lower ranks then Engineer firefighter need to go to the Engines and wait for Engineer Firefighter or higher rank, if there are no avivable, they need to request premission for usage of Engine ((If there is no higher rank online, feel free to respond to there...)).

When arriving at the scene, park the truck properly and quickly grab the hoses from the truck, attach one to the truck and hydrant, second hose just to the truck and start spraying the exterior of the building. Some units should grab Gas Masks, Gas Tanks and a hose or fire estinguisher and then go inside and secure for the victims that are inside and shut down the fire that's inside. MAKE SURE to check all of the rooms in case there is a victim in the building.